Mustang Marker Light Assembly Pair (1968) Installation Instructions

• 
• 
• 
• 

1968 Pair of Mustang Marker Light Assemblies

These Marker Light Assemblies will fit 1968 Mustangs.

Save yourself some time and money with these Marker Light Assemblies for 1968 Mustangs! They come with all of the required hardware, including a lens, lens gasket, amber bulb, housing, and the correct wiring. Includes parts for both sides!

This Install Also Applies To:

• Mustang Side Marker Lamp Bracket 1968-1968
• Mustang Marker Light Lens Gasket Front 1968
• Mustang Marker Light Lens With Gaskets 1968

Tools Required:

• Socket and Ratchet

Install Difficulty:

• 
• Easy Project

1. To start installing the new Mustang marker light assembly, remove one of the original lighting assemblies. There are two bolts that hold the lighting assembly to a bracket on the inside of the fender well. Remove the bolts, and both elements are able to be removed.

2. The Mustang marker lights in this set come with all required retainer brackets, nuts, gaskets, bulbs and wiring necessary.

3. Hold the Mustang side marker lamp bracket on the back of the fender.

4. Feed the wiring through the bracket and push the Mustang marker light lens and gasket into the fender opening. The trim will sit against the fender.

5. Fasten the Mustang marker light to the bracket by tightening retaining nuts onto the assembly’s threaded studs.

6. Repeat for the opposite side and enjoy your new Mustang marker light assembly!