Drake Muscle Cars Black 4" Billet Antenna Mustang 10-14
Highlights
- Billet Aluminum Construction
- Anodized Black Finish
- 4" Tall Antenna
- Easy Installation
Drake Muscle Cars Black 4" Billet Antenna for 2010-2014 Mustang models.
Upgrade the exterior styling of your 2010-2014 Mustang with this black 4" billet antenna from Drake Muscle Cars. Replacing the tall factory antenna with a sleek, low-profile design gives your S197 a cleaner, more aggressive appearance without sacrificing quality. Measuring just four inches tall, this antenna is the perfect finishing touch for a customized look.
Features and Benefits:
- Fits 2010-2014 Mustang models
- Low-profile 4" antenna design
- Precision-machined from 6061-T6 billet aluminum
- Durable black anodized finish
- Provides a custom exterior appearance
- Includes antenna base and mount
- Direct-fit installation
- No modifications required
- Quality construction for long-lasting durability
Precision-machined from premium 6061-T6 billet aluminum, this antenna features a durable black anodized finish for long-lasting corrosion resistance and style. The kit includes the antenna, base, and mounting hardware for a straightforward installation with no modifications required, making it an easy upgrade for any Mustang enthusiast.
Vehicle Fitment:
- 2010-2014 Mustang
Please Note:
- Includes antenna, base, and mounting hardware.
- No modifications are required for installation.
- Drake Muscle Cars Billet Antenna Tool (HW1509) is recommended for easier installation and is sold separately.
California Residents: Proposition 65 Warning
Related Categories: Mustang Antennas, Mustang Audio & Stereo
Installation Difficulty
Novice skill is required for this installation.
Installation Videos
Video Transcript
We elected to go with the black billet antenna to match the graphics on our Gotta Have It Race car. Step one for installing the antenna is to simply unthread the factory mast. Place the mast aside. Now, you want to grab your removal tool so you can remove the base of the antenna. The removal tool has four prongs on it to match up with the four holes around the base. Wind it up and turn to remove. You want to remove the metal insert from the factory base as well as the rubber sleeve in the bottom, as both parts will be used on the new antenna.
Now, you install a rubber grommet onto your new billet base. Simply stretch into place. There's a little lip that will hold it on. There are two plastic alignment valves inside the billet antenna that line up with the two slots on the original antenna itself. Now, you want to reinstall a factory sleeve to make sure the antenna doesn't fall down under the quarter panel; you can use the new mast to hold it in place. Put a couple threads in, pull the antenna up, slide the insert down over it, and begin to thread it on. So we get a few threads. You can remove the mast. Get your insert tool that you used to remove it, and thread it in, thread it on.
Now, you want to get your billet base cover and the mast, place the base cover on top, put the mast through, begin to thread it so it gets tight, turn both from about a quarter turn, and the installation is finished. The only one special tool required. This installation is pretty straightforward. It should take you no more than about 10 to 15 minutes to install your antenna. You should see no adverse effect to your radio reception whatsoever and you'll be back on the road in no time.
