Power Window Kit With Black Console Switches Mustang Coupe/ Convertible 1969-1970

Stop messing around with manual crank windows—convert them to electric with this Power Window Kit from CJ Pony Parts! This kit includes new console switches to control the front windows and rear quarter panel windows and fits 1969-1970 Coupe and Convertible Mustangs.

Features and Benefits:
- Regulators Made in the USA
- Made of 1018 Cold Roll Steel 
- Bronze Oilite Thrust Bearings
- AC Delco OEM Motors for Top Quality and Performance
- Versatile Mounting Locations
- Hassle-Free Installation

This kit comes with new power regulators featuring AC Delco motors for the front and rear quarter panel windows, a labeled wiring harness for easy installation and sleek chrome-plated switches. It also includes a conduit to protect the wires from traveling through the doors and getting damaged.

The regulators use the original glass channels and bolt directly into the original mounting holes with only small modifications to the door panels. They are manufactured here in the USA using 1018 cold roll steel with bronze Oilite thrust bearings at the pivot points. The gear plates are treated for longer teeth life as well. Each regulator has an AC Delco OEM motor to ensure the highest quality and performance over a longer service life.

Kit Includes:
- New Power Regulators (4)
- New AC Delco Power Window Motors (4)
- Black Illuminated Double Button Switches (2)
- Complete and Labeled Wiring Harness (2)
- Conduit (2)

This kit’s switches are black with white markings and can be illuminated with the proper wiring setup. Each switch has a double button to control two windows and comes attached to a complete wiring harness. The harness’ wires are labeled for correct positioning and are fused to allow window operation without the engine running. The black wire is the ground and should be attached to clean metal to ensure a proper ground. The red/orange wire is the 12V hot feed.

Tech Tip: Original glue-in style door glass found in 1969 and some 1970 Mustangs may be too weak to handle the new power regulators; it is recommended to replace the old glue with new, stronger glue, or to convert to 1970 bolt-in style door glass.

Please Note: We recommend using the crank handle style switches so you are not left with a hole in your door panels where the factory regulator would come through.