Cowl Vent Grille Reproduction Black Mustang 1983-1993
Highlights
- Increased Thickness
- High Quality Reproduction
- Correct Mounting Screw Holes
- Fits 1983-1993 Mustang
Black Reproduction Cowl Vent Grille for all 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992 and 1993 Mustangs.
Is your cowl vent grille damaged due to years of being out in the harsh outdoor elements? Replace your damaged or missing cowl vent grille with this high quality reproduction. This reproduction cowl vent grille is manufactured out of a high quality plastic that has the correct contour, making the perfect fit on your metal cowl area. This cowl will fit all 1983-1993 Mustangs.
Features and Benefits:
- High Quality Reproduction
- Made Using Original Ford Blueprints
- Correct Mounting Screw Holes
- Increased Thickness
This is one of the highest quality parts, they use the original blueprints that Ford used when manufacturing this part. All the mounting holes and washer nozzles are properly placed on this cowl vent grille. When manufacturing this cowl they make the cowl thicker in some places that tend to break over time. The black plastic matches the black trim that is around your Mustang.
What kind of shape is your Fox Body Mustang in? If the body of your Mustang looks pretty good, focus on making some upgrades with dozens of body kits, spoilers and more from CJ Pony Parts. This will make your Mustang look great instead of just good. However, if your 1979-1993 Mustang could use some body and sheet metal repair, CJ Pony Parts can assist you with that too. We offer a wide selection of new floor pans, fenders and more.
California Residents: Proposition 65 Warning
Related Categories: Mustang Parts, Mustang Body & Sheet Metal, Mustang Cowl Area
Installation Videos
Video Transcript
While the rest of our convertible is in really good shape, the cowl is typical of an older Fox Body. We've got some cracks on the edge here. The entire thing is dated. It's time for a new one. The installation is very straightforward; the only tool required is a Phillips head screwdriver.
We're going to start by removing our wipers. We're going to lift up on the arm and pull this little tab out, rest the arm against the tab, and slide the wiper off. Now we'll remove the six screws that hold the grille on: two here, two in the middle, and two on the other side. Once we remove the screws, the grille will just lift straight off. We're going to reach underneath and disconnect the washer nozzle hose. Before you throw your old grille away, you want to make sure you get the washer nozzle off of it. You'll need that for your new grille.
We'll install the nozzle on our new grille, and it's ready to install. Before we install the new grille, we're going to clean up this area and replace these screw retainers as well. Easy way to get these out is to push them through and pull them out from the bottom.
We'll install the new screw retainers, and press down and click them into place. Now we're ready to install the new grille and reconnect the washer nozzle. We're going to tighten these down snug; you don't want to over- tighten them, since you're tightening into plastic. Now the last step is to reinstall our wipers. We'll line them up, tilt them forward again, push the clip down, and release. And our installation's finished.
A few minutes of work made a huge difference on our convertible. Installation should take you no more than about 10 minutes. You'll be back on the road in no time.
