Legendary Wheel Co. 17"X8" HB45 Alloy Wheel Mustang 65-73 Gold Haze/ Machined

If you're searching for a part that will enhance your style and performance without sacrificing the vintage style of your early model Mustang, then you need to check out this Legendary Wheel Co. Gold Haze and Machined 17" x 8" HB45 Alloy Wheel (P/N: LW90-70854F) now available at CJ Pony Parts. This wheel is specifically for all 1965-1973 Mustangs and can be purchased individually or as a staggered set.

This wheel is constructed from cast aluminum and finished in a gold haze. Its one piece design and the added clear coat make it more durable against the elements and debris, so it will hold up over time just like your classic Pony. The machined lip adds a modern touch that will bring your Pony into the 21st century while complimenting its body model.

Legendary Wheel Co's HB45 Alloy Wheel is built to fit most 5-lug Mustangs with the original 5" x 4.5" both pattern and 4.75" of backspacing. It will also clear most aftermarket brake kits. This 17" x 8" wheel is designed for rear fitment only in 1969-1973 Mustangs, while the staggered set will fit on any 1965-1973 Mustang. If you order a staggered set, you will receive two 17" x 7" wheels for the front and two 17" x 8" wheels for the back, offering your classic pony an aggressive stance. The square set of wheels will provide an authentic look and feel without needing any modifications. Be sure to order your new wheels now from CJ's!

Wheel LW90-70854F Information:
- Size: 17” x 8”
- Lugs: 5 x 4.5”
- Finish: Gold Haze with Machined Lip
- Backspacing: 4.75”
- Weight: 20 lbs
- Offset: 1mm
- Center Cap: Included 

*Lug nuts for installation (P/N: WHLLN19) are sold separately.
*The square set of wheels comes with four (4) 17"x8" wheels.
*The staggered set of wheels comes with 17”x7” front wheels and 18"x8" rear wheels.
*Legendary Wheel Co. “L” logo Center caps are included with the Legendary Wheel Co. wheels. Spinner style center caps (LWCSAS) are sold separately. Lug nuts are not included, CJ Pony Parts carries the correct lug nuts for installation of Legendary Wheel Co. wheels.

Additional Notes:
- This 17”x8" wheel is intended for rear fitment only in 1965-1968 Mustangs, as wider wheels can rub on the front wheel opening when turning. The square set of 17"x8" wheels are recommended for 1969-1973 Mustangs only.
- These wheels require the use of extended thread lug nuts WHLLN118 or extended wheel studs.

Tech Tip: Even though these wheels are intended to fit the rear of most 5-lug 1965-1973 Mustangs with the original 5 x 4.5" bolt pattern and 4.75" of backspacing. It is a general rule of thumb, you should always measure and verify clearance before ordering aftermarket wheels, as modifications may, or will be necessary for fitment on your classic Mustang.