PerTronix Distributor Flame-Thrower Black Female Cap Cast Ignitor 289/302 1965-1973

Pertronix: D134600
MSRP: $350.21
CJ's Low Price:
$180.99
Ships in 5-7 Days This item typically ships within 5-7 days1406332800
Earn 180 RPM Points What's this?
DIST35
Play PerTronix Distributor Flame-Thrower Black Female Cap Cast Ignitor 289/302 1965-1973 Video 1

Product Description

PerTronix Flame-Thrower Black Female Cap Cast Distributor with Ignitor for 1965-1973 Mustangs with a 289 or 302 Engine.

PerTronix distributors are designed for maximum ignition performance and easy installation all at a price you can afford. Replace your outdated points or electronic distributor with this performance proven distributor which features PerTronix's legendary Ignitor electronics. All this in a cast housing that looks closer to being period correct.

Delivering twice the voltage to the spark plugs, Ignitor electronic ignitions will increase horsepower, improve fuel economy, and extend spark plug life. The Ignitor system is designed for use with most point-type coils, but optimal performance is achieved when used with PerTronix's Flame-Thrower 40,000 volt coil. A solid-state electronic ignition system means you will never change points again.

Flame-Thrower Distributor with Ignitor Features:
- 2:1 improvement over points in current fall time for increased coil output
- Rotating cobalt magnets trigger a Hall Effect integrated circuit
- No points to burn or moving parts to wear out
- No black box to clutter the engine compartment
- Stable timing, no need for any adjustments
- Will trigger most multi-spark CD ignitions
- Uncomplicated wiring makes for easy installation
- All new cast housing molded after the original Ford distributors
- Tailored advance curve for optimum performance
- Adjustable vacuum canisters for extra tenability
- High dielectric strength cap and rotor with brass contacts
- Legal in all 50 states (C.A.R.B. E.O. #D-57-23)

Similar Mustang Parts

similar mustang parts More Mustang Distributors  

Mustang Applications

This product will fit the following Ford Mustang years:

Product Reviews

Write a Review
1965 mustang 289 distributor install
I was very impressed with how easy this distributor and coil were to install.Was about a two hour time line. Once I found TDC on the stock distributor, pulled it out, pushed the new one in, cut the wires to length ,put new wires on. It fired right up. Set the timing and instantly noticed the car idled smother. And fires up much easer.I highly recommend this product.
Jeffrey Lopez, Glendora, Ca. June 6, 2013
1 Results

Product Video

By Bill Tumas: We're here with a Pertronix Flame-Thrower distributor for your 1965 through 1973 Mustang equipped with a 289 or 302. Pertronix designed the Flame-Thrower to be a high performance, low cost replacement distributor. It features a female cap, easy two wire connection to put out approximately twice the spark of your conventional ignition. The Flame-Thrower distributor gives you all the benefits of their igniter ignition system in an easy to install drop-in distributor.