Classic Instruments Holley Sniper II Zeus-Link Interface Module

This Zeus-Link Interface Module (SN73Z-S2) from Classic Instruments connects to a Holley Sniper 2 ECU, reading your vehicle's CAN BUS info to figure out what parameters can be used best with which gauges. This module drives six (6) standard gauges and two (2) auxiliary gauges of your choice, all of which are managed through a mobile app.

Features and Benefits:
- All-inclusive gauge interface unit
- Queries vehicle to determine correct parameters for each gauge
- Spaces for 6 standard gauges: speedo, tach, fuel, oil, volt, temp
- Spaces for 2 auxiliary gauges of your choice
- Set-up and managed through mobile app in App Store or Google Play
- App provides a virtual gauge screen that aligns with dash instruments
- Allows you to choose your gauges and how they get their signals
- Displays values, allowing you to cycle through to verify correct outputs
- Warning/check engine light outputs on Zeus-Link and external contacts to light a dash light
- Features dash light connection
- Harness plugs directly into Zeus-Link, then to Holley ECU/OBD
- Holley harness has additional Holley ECU connector for other devices
- On-board diagnostic lights give status of power, BLE, and data on circuit board
- Pass-through CAN port connection for other CAN devices
- Compatible with all Classic Instruments sending units and gauges

The app that controls this module allows you to choose which gauges your vehicle has and where their signals come from. It displays a virtual screen that lines up with your car's instruments along with all the outputs which you can verify are correct. The harness plugs directly into the unit, which then connects to the Holley ECU or OBD. The Zues-Link module is compatible with all of Classic Instruments' sending units and gauges!