Similar Mustang PartsMore Mustang Oil System
Easy to install, did it with the engine in car, used The Right Stuff in the corners of the timing cover and rear seal as suggested in Mustang monthly. The installation plastic keepers made it a lot easier holding the gasket and then the pan in place. Let sit over night but you can start up after just 10 minutes. Out of 10 it was a 6 to put in . Start from the center and torque bolts to about 5 lbs then go back starting from the center again to 9-10 lbs.The gasket has metal rings under the rubber at every bolt hole so you do not over tighten the gasket I used a 1/4 inch torque wrench , easy to handle, not to big , can buy for about $30. 12 inch lbs is equal to 1 ft. pound.You must take your frame connecting bar off and lower the steering linkage. Take your time, don't be in a hurry.
You Might Also Like
CJ's Low Price:$52.99
CJ's Low Price:$67.99
CJ's Low Price:$17.99