FiTech Intake Kit Ultimate LS W/O Trans Control 750HP Short Runner LS1/ LS2/ LS6

For a standalone self-tuning ECU system on your LS engine, this FiTech unit also includes a low-profile Intake. These systems are easy to install and provide modern performance on your restomod or project vehicle. These systems are simple enough for the DIYer, with all the features a pro would want too.

Features and Benefits:
- Low profile, 102mm inlet, Fabricated 3mm thick aluminum sheet metal
- TIG welded intake manifold with 1500-6500 rpm power-band up to 750 HP to the flywheel
- 3 BAR MAP sensor for power adder applications
- Supports up to 30 PSI boost
- Billet Fuel rails with AN fittings and fuel crossover
- Self-learning ECU with touch screen controller for easy setup and configuration

This system is ready to go with everything needed to complete the induction system of your LS engine and get you on the road easily and faster than any system on the market today. Forget sourcing mismatched parts and cutting and splicing old harnesses and re-flashed ECU’s from “Craigs List” tuners.

FiTech’s Ultimate EFI is a complete Kit. Suitable for that junkyard 5.3 to a stroker 427, we have you covered! Check out the list of features and you will wonder why it’s never been so simple to ditch that old factory hardware or top off that fresh long block.

We have taken the work out of getting your new or pull-out LS up and running in a flash. That’s why we call this intake manifold kit the Ultimate EFI.

Specifications:
- Intake manifold is 6.5 inches tall.
- 102mm high flow cable operated throttle body sits at 7 degrees.
- Throttle body will clear any stock truck accessories depending on the type of water pump, if there is truck water pump accessory clearance interference you will need to get a new water pump bracket.

This Kit Includes:
- 102mm billet aluminum throttle body.
- Hand-held controller with color touch screen and cable.
- Windshield mount for touch screen controller.
- LS ECU.
- 55 lb/hr Injectors.
- High volume fuel rails.
- Mounting bracket.
- -6 AN fittings.
- Screws to mount brackets.
- AN fittings and fuel crossover.
 Fabricated 3mm thick aluminum sheet metal TIG welded intake manifold and bolts.
- Plug and play primary wiring harness.
- 3 BAR MAP Sensor.
- Throttle Position Sensor.
- Idle Air Control Motor.
- Idle Air Temperature Sensor.
- Dual Wide band O2 Sensors.
- Stainless Oxygen Sensor bung kit (Clamp or weld on).
- Two programmable fan control outputs.