FiTech Intake Manifold Kit Ultimate LS Short Runner With Trans Control 1000HP Chevrolet LS1/ LS2/ LS6

The FiTech Ultimate LS Intake Kit will get almost any LS1, LS2 or LS6 up and running for custom applications. Whether you're swapping into an old C10 or an old Mustang, this kit's wide range of features will give you everything you need for proper operation.

Features and Benefits:
- Low profile, 102mm inlet, Fabricated 3mm aluminum TIG welded intake
- 1500-6500 RPM power-band up to 1000 HP to the flywheel
- Contains a 3 BAR MAP sensor for power adder applications
- Supports up to 30 PSI of boost
- Self-learning ECU with touch screen controller for easy setup
- Sequential fuel and spark control with individual cylinder trim
- Two programmable fan control outputs
- Tach output driver for most tachometers (5V)
- Output driver for most speedometers
- Compatible with car and truck coils
- On the fly programmable target AFR and timing (if desired)
- Custom wire harness (uses factory coil pack sub harness)
- Trans control feature works on 4L60, 4L65, 4L80 or 4L85 GM transmissions

FiTech’s Ultimate EFI is a complete Kit. Suitable for that junkyard 5.3 to a stroker 427. Check out the list of features and you will wonder why it’s never been so simple to ditch that old factory hardware or top off that fresh long block. We have taken the work out of getting your new or pull-out LS up and running in a flash. That’s why we call this intake manifold kit the Ultimate EFI.

This intake manifold Kit comes with electronic transmission control. This option is used when operating a GM electronically controlled automatic transmission. The Ultimate LS ECU has the ability to control the shift point, shift firmness, when to downshift properly, and all other features involved when controlling the transmission.

The trans control feature is suitable for 4L60, 4L65, 4L80 or 4L85 GM transmissions. If using transmission control connect the two sides of the trans connector to the sub-harness and connect this to the connector on the transmission. Once connected to the transmission you are ready. If not using transmission control leave the connectors untouched.

This Kit Includes:
- 102mm billet aluminum throttle body
- Hand-held controller with color touch screen and cable
- Windshield mount for touch screen controller
- LS ECU
- 80 lb/hr Injectors
- High volume fuel rails
- Mounting bracket
- -6 AN fittings
- Rails
- Screws to mount brackets
- AN fittings and fuel crossover
- Fabricated 3mm thick aluminum sheet metal TIG welded intake manifold and bolts
- Plug and play primary wiring harness
- 3 BAR MAP Sensor
- Throttle Position Sensor
- Idle Air Control Motor
- Idle Air Temperature Sensor
- Dual Wide band O2 Sensors
- Stainless Oxygen Sensor bung kit (Clamp or weld on)
- Two programmable fan control outputs

Engine Fitment:
- 4.8 L / 293 c.i. LR4, LS1, LS2, LS6
- 5.3 L / 325 c.i. L33, L59, LM4, LM7
- 5.7 L / 346 c.i. LS1, LS6
- 6.0 L / 364 c.i. LQ4, LQ9, LS2

Tech Tip:
- Intake manifold is 6.5 inches tall.
- 102mm high flow cable operated throttle body sits at 7 degrees.
- Throttle body will clear any stock truck accessories depending on the type of water pump, if there is truck water pump accessory clearance interference you will need to get a new water pump bracket.