BMR K-Member Without Spring Perches Red Motor Plate Version Mustang 1979-2004

If you’re looking for traction and handling gains on your 1979-2004 Mustang with a motor plate, an aftermarket K-member is the key. Out-maneuver your opponents on the strip with the BMR Red K-Member Without Spring Perches from CJ Pony Parts! A full 31-1/2 lbs. lighter than the stock model, this K-member only weighs 17 lbs. offering a drastic increase in weight transfer and traction. The high 1-1/2-inch DOM steel tubing and 3/16-inch steel plate are built in the USA for maximized strength and durability giving you the superior edge on the strip and the street.

Features and Benefits:
- Bolt-On Installation
- Red Powder Coating
- Made in the USA
- 31-1/2 Lbs. Lighter than Factory Model
- Reduces Front End Weight
- DOM Steel 1-1/2” Main Cross Bar
- 3/16” Steel Plate
- Optimizes Room for Performance Upgrades

Designed as a direct-fit upgrade, this K-member features a bolt-on installation and accepts coilover springs and is compatible with factory-style springs with the use of the BMR Bolt-On Spring Seat (HW4817). Complete with a red powder-coated finish, this K-member is corrosion resistant and will accent your pony perfectly!

Please Note: The BMR K-Member was designed for 1979-2004 Mustang when the customer uses a Motor Plate. This K-Member does not have any engine mounts.

Tech Tip: The BMR K-Member uses factory mounting points and is designed for coil-over struts and springs. However, by simply adding the BMR bolt-on Spring Seat (HW4816), you can use a factory style spring setup.