COMP Cams Steel Street Lock Set 1 Groove 7 Degree Angle 11/32" Stem Size

COMP Cams: 601-16
CJ's Low Price:
1455062400 97
Earn 17 RPM Points What's this?
COMP Cams Steel Street Lock Set 1 Groove 7 Degree Angle 11/32" Stem Size

Product Description

Set of COMP Cams 1 Groove 7 Degree Angle 11/32" Stem Size Steel Street Locks.

These hardened steel, single groove Steel Street Locks with a 7 lock angle and 11/32" valve stem size are perfect replacement locks for stock engine rebuilds. They are recommended for street applications with lighter valve spring loads only.

Set Includes:
- 16 Pairs of Hardened Steel Street Locks: 1 Groove, 7 Angle, 11/32" Stem Size

Tech Tip: It is extremely important to make sure the valve locks match the valve size. There should always be a relatively small gap between the two halves of the lock when they are correctly positioned on the valve stem. If the two halves fit together without a gap, they are too large. If the locks fit tight to the stem and leave a gap between the middle of the lock and the outside diameter of the stem, the locks are too small.

Many engine builders believe that the tang inside of a valve lock holds the retainer and valve spring in place while the engine is running. This is not true. The cross-section of material in the tang is not strong enough to withstand open spring loads of 1,000 pounds or greater. The only purpose of the tang is to temporarily locate the lock, retainer and spring relative to the valve until the taper of the retainer can seat around the outside surface of the lock. This creates a "collet" effect that holds the two together. The more spring force exerted on the retainer (as the valve opens) the more force applied by the "collet" effect to keep the retainer and lock in place.

Product Reviews

Write a review

Product Questions


You Might Also Like