FiTech Ultimate LS Intake Kit 1000HP Short Runner Without Trans Control LS7

If you're in the market for a top-of-the-line intake kit for your LS7 engine, look no further than the FiTech Ultimate LS 1000HP Short Runner Intake Kit (70036). This low-profile intake manifold boasts a durable 3mm thick aluminum sheet metal construction and is TIG welded for extra strength. With a power band ranging from 1500-6500 RPM and the potential to reach up to 1000 HP at the flywheel, this kit is not for the faint of heart.

Features and Benefits:
- Low profile intake manifold
- 102mm inlet, fabricated 3mm thick aluminum sheet metal TIG welded
- 1500-6500 RPM power band up to 1000 HP to the flywheel
- 24X and 58X crank and cam compatible
- Two programmable fan control outputs
- TPS, IAC sensor, and knock sensor control
- Tach output driver for most tachometers (5V)
- Output driver for most speedometers
- Compatible with car and truck coils
- On-the-fly programmable target AFR and timing (if desired)
- Billet fuel rails with AN fittings and fuel crossover
- Self-learning ECU with touchscreen controller
- Dual Bosch wide band with dual trim control
- Sequential fuel and spark control with individual cylinder trim
- 3 BAR MAP sensor automatically detects up to 30 psi boost
- Custom wire harness (uses factory coil pack sub harness)

The manifold is 24X and 58X crank and cam compatible, making it a versatile option for a range of LS7 engines. Additionally, the two programmable fan control outputs, TPS, IAC sensor, knock sensor control, and on-the-fly programmable target AFR and timing make this kit a standout option. Compatible with both car and truck coils, this intake kit offers your ride superior performance and customization.

Kit Includes:
- 102mm billet aluminum throttle body
- Hand-held controller with color touch screen and cable
- Windshield mount for touch screen controller
- LS ECU
- 80 lb./hr. injectors
- High-volume fuel rails
- Mounting bracket
- -6 AN fittings
- Screws to mount brackets
- AN fittings and fuel crossover
- Fabricated 3mm thick aluminum sheet metal TIG welded intake manifold and bolts
- Plug-and-play primary wiring harness
- 3 BAR MAP sensor
- Throttle position sensor
- Idle air control motor
- Idle air temperature sensor
- Dual wide band O2 sensors
- Stainless oxygen sensor bung kit (clamp or weld on)
- Two programmable fan control outputs

Tech Tips:
- 102mm high flow cable operated throttle body sits at 7 degrees
- The throttle body will clear any stock truck accessories depending on the type of water pump
- If there is truck water pump accessory clearance interference you will need to get a new water pump bracket
- Intake manifold will fit Square Port LS7 cylinder heads
- If a throttle body cable mounting bracket is required, use P/N: FI70063

Vehicle Fitment:
- 1965-2010 Mustangs
- 1948-1979 F-100s
- 1966-1977 Broncos
- 1960-1987 C10s