FiTech Ultimate LS Intake Kit 1000HP Long Runner Without Trans Control LS1/ LS2/ LS6

The FiTech Ultimate LS 1000HP Long Runner Intake Kit (70032) offers your ride serious performance that can help you reach extreme horsepower capabilities. A low-profile intake manifold, 102mm inlet, and 3mm thick aluminum sheet metal TIG welded construction provide superior strength and heat dissipation capabilities. This kit is compatible with car and truck coils and supplies an adjustable 1500-6500 RPM power band up to 1000 HP at the flywheel. This complete kit allows you to boost and upgrade the induction system to your LS engine without the guesswork of whether you have the right parts for the job.

Features and Benefits:
- Low profile intake manifold
- 102mm inlet, fabricated 3mm thick aluminum sheet metal TIG welded
- 1500-6500 RPM power band up to 1000 HP to the flywheel
- 24X and 58X crank and cam compatible
- Two programmable fan control outputs
- TPS, IAC sensor, and knock sensor control
- Tach output driver for most tachometers (5V)
- Output driver for most speedometers
- Compatible with car and truck coils
- On-the-fly programmable target AFR and timing (if desired)
- Billet fuel rails with AN fittings and fuel crossover
- Self-learning ECU with touchscreen controller
- Sequential fuel and spark control with individual cylinder trim
- 3 BAR MAP sensor automatically detects up to 30 psi boost
- Custom wire harness (uses factory coil pack sub harness)

The self-learning ECU with a touchscreen controller and on-the-fly programmable target AFR gives you complete control of your system and lets you fine-tune your machine to how you want it. The sequential fuel supply and spark control with individual cylinder trim automatically detect up to 30 psi boost. This kit is the perfect choice for reaching maximum horsepower for your LS1, LS2, or LS6 engines.

Kit Includes:
- 102mm billet aluminum throttle body
- Hand-held controller with color touch screen and cable
- Windshield mount for touch screen controller
- LS ECU
- 80 lb./hr. injectors
- High-volume fuel rails
- Mounting bracket
- -6 AN fittings
- Screws to mount brackets
- AN fittings and fuel crossover
- Fabricated 3mm thick aluminum sheet metal TIG welded intake manifold and bolts
- Plug-and-play primary wiring harness
- 3 BAR MAP sensor
- Throttle position sensor
- Idle air control motor
- Idle air temperature sensor
- Dual wide band O2 sensors
- Stainless oxygen sensor bung kit (clamp or weld on)
- Two programmable fan control outputs

Tech Tips:
- 102mm high flow cable operated throttle body sits at 7 degrees
- Throttle body will clear any stock truck accessories depending on the type of water pump
- If there is truck water pump accessory clearance interference you will need to get a new water pump bracket
- Intake manifold is 6.5 inches tall
- If a throttle body cable mounting bracket is required, use P/N: FI70063

Vehicle Fitment:
- 1965-2010 Mustangs
- 1948-1979 F-100s
- 1966-1977 Broncos
- 1960-1987 C10s