FiTech Ultimate LS Intake Kit 1000HP Long Runner With Trans Control LS1/ LS2/ LS6

The FiTech Ultimate LS 1000HP Long Runner Intake Kit (70033) with Trans Control is the perfect choice for taking your LS1, LS2, and LS6 engines to the next level of performance. This intake kit is suitable for 4L60, 4L65, 4L80, or 4L85 GM transmissions and lets you control the shift point, shift firmness, and know when to downshift properly with greater precision. The low-profile intake manifold features a 102mm inlet combined with a 3mm thick aluminum sheet metal construction TIG welded together. The kit features a 1500-6500 RPM power band up to 1000 HP to the flywheel and is equipped with an output driver for most speedometers.

Features and Benefits:
- Transmission control suitable for 4L60, 4L65, 4L80, or 4L85 GM transmissions
- Automatically control shift point, shift firmness, and downshift
- Low profile intake manifold
- 102mm inlet, fabricated 3mm thick aluminum sheet metal TIG welded
- 1500-6500 RPM power band up to 1000 HP to the flywheel
- 24X and 58X crank and cam compatible
- Two programmable fan control outputs
- TPS, IAC sensor, and knock sensor control
- Tach output driver for most tachometers (5V)
- Output driver for most speedometers
- Compatible with car and truck coils
- On-the-fly programmable target AFR and timing (if desired)
- Billet fuel rails with AN fittings and fuel crossover
- Self-learning ECU with touchscreen controller
- Sequential fuel and spark control with individual cylinder trim
- 3 BAR MAP sensor automatically detects up to 30 psi boost
- Custom wire harness (uses factory coil pack sub harness)

Compatible with car and truck coils, this kit also conducts on-the-fly programmable target AFR and timing. The self-learning ECU is supported by a touchscreen controller for complete sequential fuel and spark control all while providing individual cylinder trim adjustments. Finally, this kit has the capability of detecting up to 30 psi boost pressure and comes with a custom harness that makes using your transmission controller easier.

Kit Includes:
- 102mm billet aluminum throttle body
- Hand-held controller with color touch screen and cable
- Windshield mount for touch screen controller
- LS ECU
- 80 lb./hr. injectors
- High-volume fuel rails
- Mounting bracket
- Rails
- -6 AN fittings
- Screws to mount brackets
- AN fittings and fuel crossover
- Fabricated 3mm thick aluminum sheet metal TIG welded intake manifold and bolts
- Plug-and-play primary wiring harness
- 3 BAR MAP sensor
- Throttle position sensor
- Idle air control motor
- Idle air temperature sensor
- Dual wide band O2 sensors
- Stainless oxygen sensor bung kit (clamp or weld on)
- Two programmable fan control outputs

Tech Tips:
- 102mm high flow cable operated throttle body sits at 7 degrees
- Throttle body will clear any stock truck accessories depending on the type of water pump
- If there is truck water pump accessory clearance interference you will need to get a new water pump bracket
- Intake manifold is 6.5 inches tall
- If a throttle body cable mounting bracket is required, use P/N: FI70063

Vehicle Fitment:
- 1965-2010 Mustangs
- 1948-1979 F-100s
- 1966-1977 Broncos
- 1960-1987 C10s