Holley Retrofit Fuel Pump Module Sniper Diecast 340 LPH In-Tank For Returnless EFI
Holley 340 LPH In-Tank Retrofit Sniper Diecast Fuel Pump Module for Returnless EFI Fuel Systems.
This new, American made Holley 19-360 340 LPH In-Tank Retrofit Sniper Diecast Fuel Pump Module for your Returnless EFI Fuel System is designed to support up to 700 EFI horsepower or 900 carbureted horsepower produced by your upgrade to an EFI fuel system. This returnless version of the fuel pump will convert your factory fuel tank or fuel cell to an in-tank EFI fuel system.
Features and Benefits:
- Installs in any fuel tank from 7” to 12” deep to fit a wide variety of applications
- Low profile design is only 1.275" thick above the tank mounting surface for added clearance
- Innovative clamping system allows you to locate the module anywhere in the tank
- The clamping system allows you to rotate the unit 360 degrees for easier clocking of the plumbing and wiring locations
- Die cast aluminum construction for corrosion resistance
- 1/4” NPT ports for a wide variety of plumbing options
- Built in Fuel Pressure Regulator
- Ideal for Terminator EFI, Sniper EFI, MSD Atomic EFI or any TBI or EFI conversion
- 340LPH pump that is E85 compatible for both return and returnless style systems
- Made In The USA
The included diecast fuel pump-hangar bracket features a low-profile design that will reduce pump vibration and is ideal for applications where the engine bay space is limited. They fit any fuel-tank depth from 7” to 12” and will protrude only 1.275” above the tank-mounting surface to accommodate numerous applications. To work flawlessly with various plumbing and wiring configurations you can install this module beside your existing sending unit anywhere in the tank and rotate it a full 360 degrees. All you need to do is connect your power-source/ground and fuel lines and you’re new pump is ready to go. No welding or fabrication is required during the installation process.
*Fuel lines are not included and must be purchased separately, (P/N: FL12). The use of a 30 Amp Fuel Pump Relay (P/N: FPRK) along with a minimum size of 12 Gauge wire is recommended for installation.
The carburetor on your car, truck or SUV is a part that you rely upon to work. Without it, your vehicle isn't going anywhere. That's why you want to make sure you get a high quality part when you replace or upgrade your carburetor, and no carburetor is going to have higher quality than one from Holley.
Order this Holley 19-360 340 LPH In-Tank Retrofit Sniper Diecast Fuel Pump Module for your Returnless EFI Fuel System today from CJ Pony Parts.
California Residents: Proposition 65 Warning
Intermediate skill is required for this installation.
This product will fit the following Bronco years:
This product will fit the following C10 years:
This product will fit the following F-100 years:
This product will fit the following Mustang years: