COMP Cams Stage 2 NSR Hydraulic Roller Camshaft 7.3L Godzilla Engine

If you're looking for a serious upgrade to your 7.3L Godzilla engine, look no further than the COMP Cams Stage 2 NSR Hydraulic Roller Camshaft (405-203-17). This street/strip performance camshaft provides high levels of mid-range torque with an operating RPM range of 1800 to 6500. With an increased horsepower of up to 75 HP and over 75lb-ft of torque at 3000 RPMs, you'll experience enhanced throttle response and towing capabilities. Don't worry about sacrificing street manners, as this camshaft maintains good drivability and even utilizes full phaser use for moderate fuel mileage.

Features and Benefits:
- Provides high levels of mid-range torque
- Street/strip performance hydraulic roller camshaft
- Operating rpm range of 1800-6500 RPMs
- Increased horsepower up to 75 HP
- Over 75lb-ft of torque by 3000 RPMs
- Maintains good street manners
- Increased throttle response
- Utilizes full phaser use for moderate fuel mileage
- Great towing and racing cam for medium to heavy vehicles
- No adjustment to factory cam phasing or ignition timing
- Made in the USA

Made in the USA and designed with an intake duration of 285 degrees, exhaust duration of 292 degrees, and lobe separation of 112 degrees, the COMP Cams Stage 2 NSR Hydraulic Roller Camshaft is the perfect choice for medium to heavy vehicles looking for great performance and towing capabilities. No adjustment to factory cam phasing or ignition timing is necessary.

Specifications:
- Computer-controlled compatible: yes
- Valve springs required: no
- Maximum advance at camshaft: 7 degrees
- RPM operating range: 1800-6500 rpm
- Grind Number: nsr279hr12
- Cam-type: hydraulic roller
- Usage: street
- California Proposition 65: yes
- Advertised intake duration: 285°
- Advertised exhaust duration: 292°
- Intake duration at .050 inch lift: 221°
- Exhaust duration at .050 inch lift: 231°
- Intake valve lift: 0.598in
- Exhaust valve lift: 0.607in
- Lobe lift intake: 0.332in
- Lobe lift exhaust: 0.337in
- Lobe separation: 112°
- Intake centerline: 105°
- Exhaust close ATDC: 4°
- Intake open BTDC: 5°
- Exhaust open BBDC: 55°
- Intake close ABDC: 346
- Lifter type: roller tappet
- Recommended cold lash setting (intake): hydraulic
- Recommended cold lash setting (exhaust): hydraulic
- Direct injection: no
- VVT compatible: yes
- Phaser requirement: limiter

Tech Tip: We highly recommend professional tuning for the best performance output from the Comp Cams Stage 2 NSR Godzilla Camshaft.

Please Note: For the best performance please use Comp Cams Phaser Limiter (P/N: 5473).